Linuxcnc terminated with an error!
13 May 2013 22:29 #34005
by ArcEye
Replied by ArcEye on topic Linuxcnc terminated with an error!
Well I was running the zipped config from page 1 so assume that all the files are still the same.
Download it and give it a go, because there are no limits etc you can just make sure you comment out NML_FILE = emc.nml in the ini if it is still there,
and you can run it as a sim.
Download it and give it a go, because there are no limits etc you can just make sure you comment out NML_FILE = emc.nml in the ini if it is still there,
and you can run it as a sim.
Please Log in or Create an account to join the conversation.
- airbornepp
- Offline
- New Member
Less
More
- Posts: 10
- Thank you received: 0
13 May 2013 23:48 #34012
by airbornepp
Replied by airbornepp on topic Linuxcnc terminated with an error!
Sorry but I don't understand (because of my limited English).
In the meantime, I redid the file tool.tbl with tooledit and the sentence "Unrecognized line skipped: POC FMS LEN DIAM COMMENT" in the log has disappeared.
In the meantime, I redid the file tool.tbl with tooledit and the sentence "Unrecognized line skipped: POC FMS LEN DIAM COMMENT" in the log has disappeared.
Please Log in or Create an account to join the conversation.
Time to create page: 0.073 seconds