LinuxCNC Uspace

I installed linuxcnc on lubuntu 19.04 as instructed, I expected that in the programs there was boot linuxcnc, there is an emc directory, now how do I have to do to start the linuxcnc suite

Is there a "CNC" section in the applications menu?

Alterantively, try "linuxcnc" from the command prompt.

thanks for the answer probably preempt RT is installed and compiled linuxcnc no

uname -a

linux giampiero-pc 5.0.19 rt 11 # 1 SMP PREEMPT RT

These are the instructions I have run

git clone github.com/LinuxCNC/linuxcnc.git emc

sudo apt install -y devscripts build-essential

sudo apt update

giampiero @ giampiero-pc: ~ / emc $ linuxcnc

Command «linuxcnc» not found, was meant:

command "linuxvnc" from deb linuxvnc (0.9.10-2build1)

Try: sudo apt install <deb name>

giampiero @ giampiero-pc: ~ / $ emc

There is much more to do to get LinuxCNC installed.
This page is not finished yet.
gnipsel.com/linuxcnc/uspace/lubuntu19-emc.html

However the instructions on this page can be used.
gnipsel.com/linuxcnc/uspace/linuxmint19-emc.html

I'll see if I can finish that in the morning.

JT

BigJohnT wrote: However the instructions on this page can be used.
gnipsel.com/linuxcnc/uspace/linuxmint19-emc.html

I could very well be asking this in the wrong place. Apologies in advance.

I've used your instructions to attempt to install the kernel for mint 19.1
gnipsel.com/linuxcnc/uspace/linuxmint19-rt.html

The new grub loads and I select the new kernel 4.19.1-rt3 and booting stops with the following screen
image missing https://i.imgur.com/JMwudgg.jpg

I'm dead in the water here. Any idea where I went wrong?