Buildbot repositories down?

tommylight wrote: Yea i did post on another thread that the servers are not down, but the access to them is limited.
Sandwich is a good idea right about now. Just as soon as i finish sipping my double choca mocha.

Oh great. Have been trying since 9 am this morning to setup a new machine

Hope things will start working soon, is there anything we can do?

ikkuh wrote:
Hope things will start working soon, is there anything we can do?

Yes, sip some more coffee !

ikkuh wrote: Oh great. Have been trying since 9 am this morning to setup a new machine

Hope things will start working soon, is there anything we can do?

You can set up a new machine from the released repositories. www,linuxcnc.org/dists is still working

What LinuxCNC version, Linux distribution and realtime kernel were you wanting to use?

andypugh wrote:

ikkuh wrote: Oh great. Have been trying since 9 am this morning to setup a new machine

Hope things will start working soon, is there anything we can do?

You can set up a new machine from the released repositories. www,linuxcnc.org/dists is still working

I had already downloaded an Debian stretch 2.7 iso and installing that works great.

andypugh wrote: What LinuxCNC version, Linux distribution and realtime kernel were you wanting to use?

Well, I just bought a new 23" 1920x1080 touchscreen monitor especially to experiment with probe-basic. Probe-basic needs at least 2.8 so I kinda wasted a day here.
Installing on a spare machine, my 7i96 needs some tweaked settings too, also needs 2.8.
And my cnc machine is a gantry style machine, with two Y axis steppers. You guessed, needs 2.8 at least.

Hopefully everything starts working soon again. I never drank so much coffee in a day,

Should be back now. It had run out of disk space.

Buildbot repositories are up again

Thx a lot