LinuxCNC is in debian now

tommylight wrote:

Bookworm has networking issues for now, the /etc/resolve.conf file is missing and a shortcut is in it's place, but it can not be overwriten.
That is to be expected as it in still in testing, just a heads up if someone want to test the "bleeding edge".

This was fixed in V 1.63 of resolvconf which was pushed to Debian on 17 Dec 2021, 5 days after it was first reported.
It is expected that resolv.conf does not exist under some conditions.
Bookworm (testing) is not really the bleeding edge. The edge is  actually the unstable branch where linuxcnc currently lives. image missing /media/kunena/emoticons/w00t.png
Can't be any less stable  than our own master branch which so  many use.
 

I tried the installation on debian 11 on a vetual machine and it worked. Thanks RODW you are doing great.

aabtech wrote:

I tried the installation on debian 11 on a vetual machine and it worked. Thanks RODW you are doing great.

Great work. Thanks for confirming it works!
Note you are no longer on in Debian 11 but Sid or unstable so I think that means you are on Debian 13 image missing /media/kunena/emoticons/smile.pngimage missing /media/kunena/emoticons/w00t.png

Got it setup with sid on my old Dell Precision I use for testing. the 5.16.04 PREEPT-RT kernel crashes on the nouveau drivers leaving me with just a cursor on reboot, but I can run off 5.10.0-9-rt ok. Overall this is pretty awesome. Good work!

I may roll back to testing in a couple weeks when this hits bookworm.