LinuxCNC RPi4 vs RPi5
09 May 2024 07:14 #300202
by l4es
LinuxCNC RPi4 vs RPi5 was created by l4es
Dear Experts,
I followed the relevant discussions about installing LInuxCNC on RPi5 but I haven't been able to find the information about LinuxCNC running on it :
forum.linuxcnc.org/9-installing-linuxcnc...nc-on-raspberry-pi-5
forum.linuxcnc.org/9-installing-linuxcnc...4-and-raspberry-pi-5
It will be really appreciated if someone could share his/her experience/observation about the performance of such configuration compared to its predecessor, RPi4, please ?
Best regards,
Khang
I followed the relevant discussions about installing LInuxCNC on RPi5 but I haven't been able to find the information about LinuxCNC running on it :
forum.linuxcnc.org/9-installing-linuxcnc...nc-on-raspberry-pi-5
forum.linuxcnc.org/9-installing-linuxcnc...4-and-raspberry-pi-5
It will be really appreciated if someone could share his/her experience/observation about the performance of such configuration compared to its predecessor, RPi4, please ?
Best regards,
Khang
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 19188
- Thank you received: 6430
09 May 2024 10:14 #300212
by tommylight
Replied by tommylight on topic LinuxCNC RPi4 vs RPi5
There are ready made images for both on the downloads page, so if you have both, download, install and test.
Do report back how it goes.
Do report back how it goes.
The following user(s) said Thank You: elovalvo
Please Log in or Create an account to join the conversation.
Time to create page: 0.063 seconds