Ver 2.9.8 Trouble when disabling EOE
- tar_san
- Offline
- Junior Member
-
Less
More
- Posts: 39
- Thank you received: 2
14 Feb 2026 12:58 #342934
by tar_san
Replied by tar_san on topic Ver 2.9.8 Trouble when disabling EOE
I upgraded to ver 2.9.8 and I did disable eoe procedure again.
But then I cound not move EtherCAT servo motor (YASKAWA). ( I could not reset error )
I have attached files about dmesg and procedure to disable eoe.
Please help me solve this problem.
But then I cound not move EtherCAT servo motor (YASKAWA). ( I could not reset error )
I have attached files about dmesg and procedure to disable eoe.
Please help me solve this problem.
Please Log in or Create an account to join the conversation.
- Hakan
- Away
- Platinum Member
-
Less
More
- Posts: 1199
- Thank you received: 423
14 Feb 2026 15:20 #342941
by Hakan
Replied by Hakan on topic Ver 2.9.8 Trouble when disabling EOE
This was a complete new install from ISO, wasn't it?
Did you install the r8168-dkms driver again?
Did you install the r8168-dkms driver again?
Please Log in or Create an account to join the conversation.
Time to create page: 0.072 seconds