7i96 Spindle Wiring

You mean a big transformer like this one!?



But knowing I can control it manually is good enough for me, for now.

If I haven't mentioned it, I bought this machine for cheap to get my toes wet with CNC-ing. No sense over engineering anything until I know I can stick with it.

I'll likely order this part then this evening and pop back in once I have it in hand so I can get some guidance on the wiring.

Something is very wrong, i can not see anything that can handle 50A on any of the old boards. That PDF must be for something different, for sure.
Moving on, since this started to move laterally pretty fast.
www.amazon.com/Konmison-Cooled-Spindle-C...d=1582669804&sr=8-24
Can something like this work for you ?
Or can you source a different motor, DC brushed one, and old angle grinder with one part of the head removed, from an electric lawnmower etc etc ?

Interesting, I cannot guarantee my Google searching found the correct PDF for that motor, but it seemed close enough. I am going to hold off on buying the RC ESC until I can better track down more accurate documents.

Unfortunately, that spindle will not work because the carriage housing on the gantry is fairly unforgiving in what it can handle. The diameter of the spindle is about 25mm, and I've struggled to find a suitable option to migrate away from the spindle that came with the machine for something that is a bit more easy to setup.

Tomorrow, must go through everything once more.

So while I was looking for more information about the motor, it dawned on me that it might be good to look up the controller information. I snapped a photo of the sticker with the model information, seen below:

The controller box is a Suregrave/Dahlgren DSC-2000, serial number 9811063H. Not sure if this rings a bell for anyone, but thought it couldn't hurt to share.

Further digging for some information on the DSC-2000 Serial Controller has me hitting some dead ends. Archive.org had this page: web.archive.org/web/20001023212117/http:...grave.com/serial.htm

Aside from purchasing the RC ESC as previously mentioned, I'm at a loss here.

Any thoughts?