I Need help for 4 axis cnc

I'm a new member of the forum I want to say hello to everyone



I discovered linux cnc while doing research. but I have little knowledge
I will be glad if you help me...

i.hizliresim.com/dLr9jD.jpg
i.hizliresim.com/qA0zqd.jpg
i.hizliresim.com/5N0j9z.jpg

I have designed such a cnc ... and in addition it has a 360 degree rotating axis.
there is a double-sided drill at the end of this axis.Drill of different diameter on 2 sides.(8 mm on one side and 10 mm on the other side) I will use it to drill the edges of the mdf.I should also note that up and down movement of this axis will be provided pneumatically

how do I configure this machine in linux cnc?
some people said post process needs to be written.Do you really need it?
I would appreciate it if you tell me where to start and what to do about it

Thank you in advance for your interest and help

Merhaba abey,
First you have to make the machine work as you need it to, then deal with post processing .
Did you build the machine or not yet ?

I started to produce CNC. I think it'il be over in 10 days. but I don't know if I can succeed the software

You are in Turkey, are you aware that you can buy ready made frames with linear rails, ready to be fitted with motors and electronics ?
doguskalip.com.tr/Product/l-cnc--kr1--kr2--kr3-kr4/1187

hi welcome
i got some 4th axis running on linuxcnc and it is a realy nice mashine setup
no problem to do XYZA or XYZb or even XYZC

yes I know but the cost is too much. I do not have much money. Did you find a problem with my design?