Mesa 7i76E first try

Mike_Eitel wrote: Does that asrock board use an intel chip for ethernet?

Uhmmmm,i don't find the mb manual,but as i know the chipset is intel,so i suppose yes

tommylight wrote: Much better.

One good thing i notice is the stepper is very silent.
Btw,as the pncconf procedure gives me some problem,i think i should manually edit the ini and hal file,but for this i need to find some guide/manual.
And annoy all of you,of course....

Jocman wrote:

Mike_Eitel wrote: Does that asrock board use an intel chip for ethernet?

Uhmmmm,i don't find the mb manual,but as i know the chipset is intel,so i suppose yes

Its Realtek, not Intel

[ 1.617653] r8169 0000:05:00.0 eth0: RTL8168g/8111g at 0xffffb41681491000, 70:85:c2:6a:f0:3d, XID 0c000800 IRQ 87
[ 1.617659] r8169 0000:05:00.0 eth0: jumbo features [frames: 9200 bytes, tx checksumming: ko]

Jocman wrote: And annoy all of you,of course....

You are welcomed to annoy us as much as you like.

Well,next step i think will be to transfer back the linux pc and all the electronics to my garage, install all to my cnc (even limit switches and so) and test if it works "in the real world". And try to import all the custom function i made in the pass time (homing,probe,etc).