plasmac message error

More
5 years 10 months ago #191846 by beauxnez
plasmac message error was created by beauxnez
hello
i'm trying to configure plasmac but i can't do it there is an error message
I use a parallel port card as in the photo below

Thanks for your help

Please Log in to join the conversation.

More
5 years 10 months ago #191848 by tommylight
Replied by tommylight on topic plasmac message error
You have two lines together in the plasmac_connections hal file.
Separate those lines.

Please Log in to join the conversation.

More
5 years 10 months ago #191857 by beauxnez
Replied by beauxnez on topic plasmac message error

tommylight wrote: You have two lines together in the plasmac_connections hal file.Separate those lines.

Thank you for the quick reply
I'm sorry but with but weak knowledge like that, but still error

Attachment not found

Please Log in to join the conversation.

More
5 years 10 months ago #191870 by tommylight
Replied by tommylight on topic plasmac message error
That wont work, you have the same pins used for parallel port AND a Mesa 7i96 ?????
Make a new config, use stepconf, NOT pncconf.
After you get that running and tuned properly, make a copy and use the configurator for PlasmaC

Please Log in to join the conversation.

More
5 years 10 months ago #191884 by beauxnez
Replied by beauxnez on topic plasmac message error
I went through stepconf
no time tonight, i will stay next week thanks

Attachment not found

Please Log in to join the conversation.

More
5 years 10 months ago #191917 by snowgoer540
Replied by snowgoer540 on topic plasmac message error
I will update the user manual to make the parallel vs mesa examples stand out a bit more to make this a bit more clear :)

Please Log in to join the conversation.

More
5 years 10 months ago #191976 by beauxnez
Replied by beauxnez on topic plasmac message error

snowgoer540 wrote: I will update the user manual to make the parallel vs mesa examples stand out a bit more to make this a bit more clear :)


the update has been made
I understand better

Please Log in to join the conversation.

More
5 years 10 months ago #192003 by snowgoer540
Replied by snowgoer540 on topic plasmac message error

beauxnez wrote:
the update has been made
I understand better


Glad to hear it, if you find anything else that’s confusing please let me know, feedback helps!

Please Log in to join the conversation.

More
5 years 10 months ago #192927 by beauxnez
Replied by beauxnez on topic plasmac message error
it works ?
i have herocut 55x non hf blowback plasma with arc output Ok
the light on linux cnc is on even with the plasma disconnected, how to invert signal in plasmac file. connection. HAL

Please Log in to join the conversation.

More
5 years 10 months ago #192928 by phillc54
Replied by phillc54 on topic plasmac message error
Not sure what io you have but if it is a 7i96 then it would something like this in your connections.hal file:
Code:
hm2_7i96.0.gpio.008.in_not

Please Log in to join the conversation.

Time to create page: 0.140 seconds
Powered by Kunena Forum