plasmac message error

beauxnez wrote:

The THC adjustment is not linear, rather sawtooth, what do I need to adjust?
 

Thats Odd because height to voltage is a very linear relationship as this chart from 16000 readings shows
Ref;  linuxcnc.org/docs/stable/html/plasma/pla...mer.html#_cnc_plasma

Is the Z axis scaling set properly?
I would venture a guess at "not"

Sorry if I don't respond to everyone, I'll take note of your advice and I'll do some tests during the day (I'm off today)

"Is the Z axis scaling set properly?
I would venture a guess at "not" "


if it is this section5.6. Initial Setup   no I did not
 

"Thats Odd because height to voltage is a very linear relationship as this chart from 16000 readings shows
Ref;  linuxcnc.org/docs/stable/html/plasma/pla...mer.html#_cnc_plasma"

Je veux dire que lors de la découpe la distance entre la tôle et la torche est de 1 mm à 3 mm

Good morning,
I've done several tests and it doesn't change anything.
setp plasmac.arc-lost-delay 0.4

I took the arc ok on the thc, on the plasma I also have an arc output ok and a reed sensor same result
the only configuration that changes in the custom.hal is:
step db arc- ok délai 10
the more I increase the delay, the longer I can cut
this could come from latency? because I re-tested I am at 55000
my new pc is a 7th generation core i5 with 8 gigabytes of ram