No, pin 11 should be connected to plasmac.move-up. The up LED is connected to plasmac.led-up which can only be on if THC is active and and up signal is present on pin 11.
hello
I finally replaced the computer, new parallel port and the card db25
I did a test with the hal show the lights change state, I will do a test during the day with the plasma
the lights in the show hall work perfectly, the THC sends the signal to the db25 card, activate the THC but the Z axis does not go up or down
I don't see where the problem comes from?
the problem does not come if I check ignore arcOK?
