plasmac message error

More
2 years 11 months ago #285859 by tommylight
Replied by tommylight on topic plasmac message error
Video of the screen while cutting?

Please Log in to join the conversation.

More
2 years 11 months ago #285860 by phillc54
Replied by phillc54 on topic plasmac message error
What is the state of the enabled switch and LED on the THC frame on the MAIN tab?
Do the up/down LEDs on the THC frame on the MAIN tab change state while cutting.
Can you post the file made from the BACKUP CONFIG button on the SETTINGS tab.

 

Attachment not found

Please Log in to join the conversation.

More
2 years 11 months ago #285866 by tommylight
Replied by tommylight on topic plasmac message error
They were both on on one of his videos, but not much else, hence my request.
I think there is a translation issue from the reply after some of my questions, so videos are much easier to work out.

Please Log in to join the conversation.

More
2 years 11 months ago #285879 by beauxnez
Replied by beauxnez on topic plasmac message error
hello the switch is activated, the up and down LEDs do not change state during cutting
THANKS 

Attachment not found

Please Log in to join the conversation.

More
2 years 11 months ago #285880 by beauxnez
Replied by beauxnez on topic plasmac message error
Je suis vraiment désolé si je n'ai pas répondu à une de vos questions, encore une fois désolé

Please Log in to join the conversation.

More
2 years 11 months ago #285882 by phillc54
Replied by phillc54 on topic plasmac message error
It would be helpful to see a video of the screen while cutting like Tom asked. Also could you monitor the HAL pins plasmac.move-up and plasmac.move-down while cutting.

Please Log in to join the conversation.

More
2 years 11 months ago #285883 by beauxnez
Replied by beauxnez on topic plasmac message error
I can't make any movements with the keyboard arrows, like before on plasmac?
by typing lspci -v it gives me the address "d100" must I change the address in qtplasmac.hal to "0xD100 out"?

Please Log in to join the conversation.

More
2 years 11 months ago #285884 by phillc54
Replied by phillc54 on topic plasmac message error
Do you have keyboard shortcuts enabled on the settings tab. 
 

Please Log in to join the conversation.

More
2 years 11 months ago #285942 by beauxnez
Replied by beauxnez on topic plasmac message error
I found, you must not check ignore arc ok otherwise the thc does not work
I set the step db arc-ok delay to 5000 otherwise I had arc ok lost
The THC adjustment is not linear, rather sawtooth, what do I need to adjust?

youtube.com/shorts/87E32FPU6MA?si=Q01okq_GWM9qxRJL

 

Please Log in to join the conversation.

More
2 years 11 months ago #286133 by phillc54
Replied by phillc54 on topic plasmac message error

I found, you must not check ignore arc ok otherwise the thc does not work
Yes, that is correct.

I set the step db arc-ok delay to 5000 otherwise I had arc ok lost

That seems to be quite a large value, have you tried doing it this way.

The THC adjustment is not linear, rather sawtooth, what do I need to adjust?

The only adjustment for external THC's from within QtPlasmaC is THC Speed%.

Please Log in to join the conversation.

Time to create page: 0.080 seconds
Powered by Kunena Forum