QtPlasmaC update problem

CFE
Offline
Elite Member

5 years 1 week ago #224147 by CFE

QtPlasmaC update problem was created by CFE

Hi all,

I have noticed that our QtPlasmaC is still on version v1.0.32 (Buildbot installation), although I have just last week and again this morning run "sudo update" and "sudo upgrade". Does anybody have clue why this is ?

Please Log in or Create an account to join the conversation.

phillc54
Offline
Platinum Member

5 years 1 week ago #224148 by phillc54

Replied by phillc54 on topic QtPlasmaC update problem

Are your apt sources pointing to "stretch" rather than "buster"

Please Log in or Create an account to join the conversation.

CFE
Offline
Elite Member

5 years 1 week ago #224149 by CFE

Replied by CFE on topic QtPlasmaC update problem

Hi Phil, the repositories are set to stretch. Cheers, Peter

Please Log in or Create an account to join the conversation.

phillc54
Offline
Platinum Member

5 years 1 week ago #224151 by phillc54

Replied by phillc54 on topic QtPlasmaC update problem

Then you will need to change them to buster, stretch has not been building master since around May.

Please Log in or Create an account to join the conversation.

CFE
Offline
Elite Member

5 years 1 week ago #224153 by CFE

Replied by CFE on topic QtPlasmaC update problem

Hi Phil, does that also mean I have to change the debian source to buster ? I run stretch at the moment.

Please Log in or Create an account to join the conversation.

phillc54
Offline
Platinum Member

5 years 1 week ago #224154 by phillc54

Replied by phillc54 on topic QtPlasmaC update problem

If you open a terminal in stretch and enter python3 what version does it return?

Please Log in or Create an account to join the conversation.

Moderators: snowgoer540

Time to create page: 0.676 seconds