Qtlathe

cmorley
Offline
Platinum Member

6 years 3 months ago #174448 by cmorley

Replied by cmorley on topic Qtlathe

So looking at the code, it should pop up a save file path dialog.
Does it not pop this dialog?

Please Log in to join the conversation.

hottabich
Topic Author
Offline
Platinum Member

6 years 3 months ago #174451 by hottabich

Replied by hottabich on topic Qtlathe

There is a path that is not correct as in the first screenshot and an error occurs — the second screenshot. It’s necessary as in the third screenshot. I have to edit the path in the dialog.

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

6 years 3 months ago #174461 by cmorley

Replied by cmorley on topic Qtlathe

add this to your handler file:

Code:

    def class_patch__(self):
        GCODE.exitCall = self.editor_exit
        GCODE.saveReturn = self.saveReturn

    def saveReturn(self, fname):
        print 'save',fname

Then run from terminal and post what gets print when you save the file.

Chris

Please Log in to join the conversation.

hottabich
Topic Author
Offline
Platinum Member

6 years 3 months ago #174471 by hottabich

Replied by hottabich on topic Qtlathe

Does not save.

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

6 years 3 months ago #174472 by cmorley

Replied by cmorley on topic Qtlathe

It wasn't supposed to save - it's only to give me information to debug.

Did you see there is a gcode error in your program?
tool 1003 is not in the tool table.

But the problem is the /../../ file path - I'll fix it tomorrow!

Chris

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

6 years 3 months ago #174575 by cmorley

Replied by cmorley on topic Qtlathe

I just push a change that should fix this problem.

Please Log in to join the conversation.

hottabich
Topic Author
Offline
Platinum Member

6 years 3 months ago #174881 by hottabich

Replied by hottabich on topic Qtlathe

Thank! Gcode Editor Save. There was a question about Mdi Touchy. Set Tooll is not available for editing corners.

Code:

G10 L1 Set Tool Table
G10 L1 P axes <R I J Q>
Set Tool Table
P = tool number
R = radius of tool
I = front angle (lathe)
J = back angle (lathe)
Q = orientation (lathe)
G10 L1 sets the tool table for the P tool number
to the values of the words.

The system is in metric units and edits in imperial units.

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

6 years 3 months ago #174894 by cmorley

Replied by cmorley on topic Qtlathe

Ok IJ fixed.

Tell me more about the units problem please.

Chris

Please Log in to join the conversation.

hottabich
Topic Author
Offline
Platinum Member

6 years 3 months ago #174897 by hottabich

Replied by hottabich on topic Qtlathe

Thank. Set Origin displays conditional units works correctly. Set Tool mm => in converts mm to inches. Or maybe that's right?

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

6 years 3 months ago #174901 by cmorley

Replied by cmorley on topic Qtlathe

Interestingly I looked at tool_offsetview.py and the code for metric mode change wasn't finished.
It always displays in machine units.

Please Log in to join the conversation.

Time to create page: 0.088 seconds