NativeCAM is Features renamed

Glad you got it working.
As a general rule, never use a root terminal, you cam do a lot of damage to the system and you do not get any warning. Sudo on a normal terminal will at least warn you if you are about to mess something up.
Regards,
Tom

Bad practice I know but I get fed up with su and sudo I often work as root despite all the warnings.

hi fernand.

it is posible ther is a littel bug with the engraphing?

when i want mill a word the first character is ok and the milling tool goes to z minus with G1 .
when lcnc starts the second character the tool goes to Z minus with G0 .

not so good for the lifetime of the tool.

pehaps its my mistake ?

nice greedings and thank you.


florian

Hi Florian,

I do not see error in ttt file but I will check when at home.
Can you post ncam.ngc that has that error ?

Fern

absolut15 wrote: ...it is posible ther is a littel bug with the engraphing?

I did not find a bug in the generated file but I found a few minor issues I will fix, like raising the mill at the end of a letter and plunging at vertical feed instead of normal.

Fern

hi fernand.

yes i think this is the problem that the tool goes to Z minus with the horizontal feed speed and not with the vertical.

here is my ncam.ngc


thanks a lot


florian


P.s.: the new milling subroutines are perfekt now!