Nativecam in Sim.axis not working
30 Apr 2020 13:31 - 30 Apr 2020 13:34 #166214
by skrap58
Nativecam in Sim.axis not working was created by skrap58
Hello Everyone.
I have Nativecam working on my machine and I love it. My issue is that I'm trying to get Nativecam working in my office in Virtualbox Ubuntu 18 installation for simulation only. I have been able to get a Nativecam tab in axis but it is blank. I believe my problem is most likely a file location problem. I have attached the linuxcnc terminal start results and the location of ncam in my file system. As always any help is immensely appreciated.
Thanks
Bill
I have Nativecam working on my machine and I love it. My issue is that I'm trying to get Nativecam working in my office in Virtualbox Ubuntu 18 installation for simulation only. I have been able to get a Nativecam tab in axis but it is blank. I believe my problem is most likely a file location problem. I have attached the linuxcnc terminal start results and the location of ncam in my file system. As always any help is immensely appreciated.
Thanks
Bill
Last edit: 30 Apr 2020 13:34 by skrap58.
Please Log in or Create an account to join the conversation.
01 May 2020 07:27 #166282
by bbsr_5a
Replied by bbsr_5a on topic Nativecam in Sim.axis not working
hi
did you set the
FEATURES bitmask in versions of LinuxCNC
<2.8 Fearture = 30
>=2.8 it is a stand alone Oword bitmask that Ncam uses to get the subroutines
did you set the
FEATURES bitmask in versions of LinuxCNC
<2.8 Fearture = 30
>=2.8 it is a stand alone Oword bitmask that Ncam uses to get the subroutines
Please Log in or Create an account to join the conversation.
04 May 2020 15:38 #166631
by skrap58
Replied by skrap58 on topic Nativecam in Sim.axis not working
Thank you for the reply. I do not know where to set the FEATURES bitmask . Could you elaborate on how to find this.
Please Log in or Create an account to join the conversation.
Time to create page: 0.202 seconds