My Newb Plasma Table Attempted Build

1/4" bore (6.35mm). Still that 1st Amazon link you posted for a 5-pack will work fine. I found my belt in the garage...20ft, and I'll need 10ft more, so I'll order a 5 meter roll of the super cheap stuff and use it in the track as the rack. The belt I already have is Gates, I'll use that as the actual drive belt.

Pat

dvn4life1972 wrote:
That's a sexy looking beast you built there Rod. Especially that Z axis, although it's all very nice indeed!

Thanks, it only took 3 months in my spare time to design and build...

rodw wrote:

dvn4life1972 wrote:
That's a sexy looking beast you built there Rod. Especially that Z axis, although it's all very nice indeed!

Thanks, it only took 3 months in my spare time to design and build...

The whole machine, or just the Z?

I'm basically running down a list of stuff to do so I can then progress into plasmac.

Had a hiccup with the float switch, got that all squared away and got my torch holder put together. I'm not real sure how to test touchoff, I have no idea how or where to get g code files to test the base machine.

It does do 1200in/min without crashing. I reduced that limit to 900in/min. And I don't see the need for that much, to be honest. Sure am glad it stopped softly every time :laugh:

Pat

dvn4life1972 wrote:

rodw wrote:

dvn4life1972 wrote:
That's a sexy looking beast you built there Rod. Especially that Z axis, although it's all very nice indeed!

Thanks, it only took 3 months in my spare time to design and build...

The whole machine, or just the Z?

The Z axis complete and Y motor assembly. Making the gantry to mount it to only took a day or so.

dvn4life1972 wrote: I'm basically running down a list of stuff to do so I can then progress into plasmac.

I'm not real sure how to test touchoff, I have no idea how or where to get g code files to test the base machine.

Pat

There are some example gcode files deployed with plasmac. A lot of people cut the Plasmac Spanner
github.com/LinuxCNC/linuxcnc/tree/master/nc_files/plasmac