QtPlasmac Updates

More
25 Aug 2019 05:41 - 20 Sep 2021 06:15 #143119 by phillc54
QtPlasmac Updates was created by phillc54
All QtPlasmaC updates will be announced in this thread, the full update list is at:
QtPlasmaC update list

PlasmaC is deprecated and is on bug fix mode only, the full update list is at:
PlasmaC 2.8 branch update list

If you wish to be notified of updates then you should subscribe to this thread.

If you have a have Run In Place installation then you should recompile every time you update your repository.

If you have a Buildbot installation you can check when it was last updated, the times are US Mountain Time which is UTC -6 hours:
QtPlasmaC.
Plasmac.
Last edit: 20 Sep 2021 06:15 by phillc54. Reason: PlasmaC was removed from master branch
The following user(s) said Thank You: tommylight
The topic has been locked.
More
24 Oct 2021 01:19 - 24 Oct 2021 01:20 #224053 by phillc54
Replied by phillc54 on topic QtPlasmac Updates
QtPlasmac update:
  • attempt to prevent erroneous run from line text on cycle start button
  • return to line 1 when canceling rfl selection
  • set kerf width and height per volt to 3 place decimals on imperial machines

    Changes submitted by snowgoer540 (Greg Carl)
     
Last edit: 24 Oct 2021 01:20 by phillc54.
The topic has been locked.
More
25 Oct 2021 03:44 #224179 by phillc54
Replied by phillc54 on topic QtPlasmac Updates
QtPlasmaC update:
  • fix virtual keyboard error message
The topic has been locked.
More
27 Oct 2021 03:25 #224462 by phillc54
Replied by phillc54 on topic QtPlasmac Updates
QtPlasmaC update:
  • updated qtvcp IndicatedPushButton


 
The topic has been locked.
More
27 Oct 2021 09:16 #224483 by phillc54
Replied by phillc54 on topic QtPlasmac Updates
QtPlasmaC update:
  • allow End key to touchoff X and Y to 0
Change submitted by snowgoer540 (Greg Carl)
The following user(s) said Thank You: tommylight
The topic has been locked.
Moderators: phillc54
Time to create page: 0.404 seconds
Powered by Kunena Forum