plasma and oxyfuel cutting on the same configuration

hello connoisseurs. I have such a situation: on the machine there is a plasma and oxygen cutter on the same carriage. After reading the documentation for qtplasmac, I did not find an answer to such a question: is it possible to start cutting with plasma or oxygen from one configuration, or do you still have to make separate configurations for plasma and for oxygen cutting?

Should be possible to have two different tools with one configuration. Tool 2 would just have an offset from tool 1.

Might not be the easiest way of dealing with it as each tool would have vastly different pierce times, kerfs, etc which could get confusing to manage.

I have no clue but I wanted plasmac to revert to normal Z axis control if a non plasma spindle number was used. Not sure if that idea got it's way into the current version, It can jog normally, so I never saw this as being a big issue to implement.