github.com/linuxcnc-ethercat/linuxcnc-et...631ab668516b649fcaaf

Posted the PR
Will be happy to get some feedback, thanks

Okay,I did a dumb haha. I got a little too hung up on pncconf not picking up the 7i73. So I started linuxcnc and ran halcmd show pin | grep 7i73 and they're all there. I'm just going to set my pins in my hal file and it should be good to go

Thanks for the quick response. I ran mesaflash --device 7c81 --addr /dev/spidev0.0 --spi --sserial and seems like it's communicating with the 7i73! I'm still not sure why pncconf isn't showing it? Is there some extra hal configuration that I need to do?

Here's the truncated output from the mesaflash command, just to show it is there
...
SSLBP port 0:
SSLBP Version: 1.43
SSLBP Channels: 2
SSLBP Baud Rate: 2500000
sserial device at channel 1: 7I73 (unit 0x130001F9)
SwRevision = 14
HwRevision = 1
NVBaudRate = 2.5Mb
NVUnitNumber = 0x130001F9
NVWatchDogTimeout = 50ms
.....

I could but that is a pretty huge overhead on a old pc. 

Ich würde das mit OR2 ,in der Maschinen hal versuchen

linuxcnc.org/docs/stable/html/man/man9/or2.9.html

Hi, 
i installed Linuxcnc 2.9.4 , and would like to use Mouse with bluetooth(logitech m350s).
kommand sudo apt update shows that adding this repository is not safe and disabled by default.
WHAT TO DO ?
 

Hi All,

My Maho 400E is still running an old version of Debian, with XFCE, that would have been the live CD back in about 2019. For my videos, I need to install simplescreenrecorder, as pointing a camera at the screen is lame.

I have tried:
sudo apt-add-repository ppa:maarten-baert/simplescreenrecorder
sudo apt update
This fails with "unable to locate simplescreenrecorder."

Please help with this. I seem to forget all linux knowledge the instant whatever I was trying to do gets done
Cheers,
Mark

 

да пожалуйста.
According to my observations, the queue error simply replaced the error  Probe tripped during non-probe move.

zippoffs wrote:

Wow, that's a lot to take in.

 

Sorry, I think I made too big a deal about some of this. That is a nice mill you've got. With a few tweaks it'll be fine.

zippoffs wrote:

Do the 220v lines going from the breaker box to the VFD also emit interference?

Yes.
Not sure how I overlooked this part of your question previously.

那是正确的。

Hallo ,
Ich möchte den 3d taster und den werkzeuglängen taster
nutzen ,die haben aber beide den gleichen Namen probe input pin. Den 3d taster habe ich auf pin 22 .funktioniert einwandfrei solange wie ich den pin 24 auskommentiert habe ,wenn ich ihn nicht auskommentiert habe startet das Programm nicht ,es kommt der Fehler probe pin bereits vergeben wie bekomme ich das gelöst .der eine wird in der Maschinen hal angegeben und der andere in der postgui.hal. Wie kann ich das Problem lösen?
 

中文是精简指令集 也封装了高压缩的复杂指令集 和英语的底层构架不一样 除了名词 其他的翻译有限失真啊