Forum Menu

Auto Tool Measurement setup,makes gmoccapy slow and difrent configation,

More
3 years 3 months ago #276023 by Aciera
Replied by Aciera on topic Auto Tool Measurement setup,makes gmoccapy slow and difrent configation,

it startes very slow , and does not look the same

Not much to go on. Starting your configuration in a terminal may give you more information in the form of terminal output while the config starts.

Open terminal type:
$ linuxcnc
and choose your configuration in the config picker.

Alternatively try:
$ linuxcnc -l

(That is a lowercase L to load the last used configuration)

Please Log in or Create an account to join the conversation.

More
3 years 3 months ago #276024 by Aciera
Replied by Aciera on topic Auto Tool Measurement setup,makes gmoccapy slow and difrent configation,
Just as a side note as this is probably not the core problem:
I don't use auto tool measurement but looking at your custom_postgui.hal shows all the lines are commented out (ie this will not do anything at all):
Code:
# Include your custom_postgui HAL commands here # This file will not be overwritten when you run PNCconf again # The next lines are only needed if the pins had been connected before #unlinkp iocontrol.0.tool-change #unlinkp iocontrol.0.tool-changed #unlinkp iocontrol.0.tool-prep-number #unlinkp iocontrol.0.tool-prepared # link to gmoccapy toolchange, so you get the advantage of tool description on change dialog #net tool-change gmoccapy.toolchange-change <= iocontrol.0.tool-change #net tool-changed gmoccapy.toolchange-changed <= iocontrol.0.tool-changed #net tool-prep-number gmoccapy.toolchange-number <= iocontrol.0.tool-prep-number #net tool-prep-loop iocontrol.0.tool-prepare <= iocontrol.0.tool-prepared

Please Log in or Create an account to join the conversation.

More
3 years 3 months ago #276025 by Kasper-001
Replied by Kasper-001 on topic Auto Tool Measurement setup,makes gmoccapy slow and difrent configation,
herre
there are some err with python ?

Please Log in or Create an account to join the conversation.

More
3 years 3 months ago - 3 years 3 months ago #276026 by Aciera
Replied by Aciera on topic Auto Tool Measurement setup,makes gmoccapy slow and difrent configation,
I see, seems you are trying to run a config from version 2.8 which used python2 on a newer version which requires python 3

You could try to replace the 3 files in the 'remap' folder of your config with the 3 files from here:
github.com/LinuxCNC/linuxcnc/tree/2.9/co.../sim/gmoccapy/python

[edit]
Actually you only need to replace one file stdglue.py
Last edit: 3 years 3 months ago by Aciera.
The following user(s) said Thank You: Kasper-001

Please Log in or Create an account to join the conversation.

More
3 years 3 months ago #276030 by Kasper-001
Replied by Kasper-001 on topic Auto Tool Measurement setup,makes gmoccapy slow and difrent configation,
thanks a lot m8,  now it runs normal. 

I'll try it out tomorrow out with the machine, image missing /media/kunena/emoticons/grin.png

Please Log in or Create an account to join the conversation.

Time to create page: 0.092 seconds
Powered by Kunena Forum