Retrofitting a 1986 Maho MH400E

Is the 1K6 Contact wired to an PLC Input?

I then will do some changes for the brake part soon.

I have an hal config for testing/setup the single stages step by step, i will comment it and then post it.


sorry for my writing, but my native language is C/C#/Assembler/Jave/Python etc. then german and unlucky at least english.....

Thanks for looking at that. The MH400E has no PLC.The 1K6 relay controls the 1K7 relay which signals that the spindel is stopped to the NC controller. 1K7 is also the inhibit on the tool changer.


I live in Wien. I can also speak german if you prefer, although it is probably better for the forum to keep this conversation in english.
Mark

The intern Philips PLC (gearchange, safty etc.) ...

But now this signal is wired to linuxcnc?

Yes, through the Mesa 7i84.

Still too cold in the basement. I sprayed one coat of green paint ont he control housing, but it will probably take all week to dry.
Mark

Faces and thread ready for the adapter, can t wait to test vector mode.