Remora - Rpi Software Stepping Using External Microcontroller via SPI

CNcninja

I have been working on the documentation for remora a bit and my next project is to create a hal page with examples to do the listed things above.

Now a full image setup and ready to go would be a good idea to get someone up and running on a known good system that they can branch from vs having to do the setup and manual install and config.

I think just a single image would be needed for all the main use cases.
3d printer
cnc mill
laser cutter
one image with a shortcut on the desktop for each use case. the user could just delete the shortcuts they dont want so they dont click the wrong one and that would be it.

I think the data is mostly together to make this now almost.

The last decision would be do we want to use a 64bit image or 32bit?
There are plus and minus to both.
I use a 64bit (and ver2.9) as it has better latency and seems faster.
But i think most people are running 32bit (v2.

Hi all,
I sent this to Scott yesterday , because  I couldn't login here yesterday, but probably went to his spam folder.
If anyone have discoveryboard or any board with stm32F407 wants to give my little hacks a try,
before I upload the sources. I'm very confident on this one, compared to what I had when attempted
to port 'picnc' that got stalled, then I found Remora.
thanks.

EDIT:
I forgot the serial port pins.
SerialPort on Port A9:A10
 TX: A9
 RX: A10

since the idea is a full disk IMG i say 64 bit

Wish i could help test this but the only stm chips i have on hand are stm32f303

mhel post=214841 userid=27650Hi all,
I sent this to Scott yesterday , because  I couldn't login here yesterday, but probably went to his spam folder.
If anyone have discoveryboard or any board with stm32F407 wants to give my little hacks a try,
before I upload the sources. I'm very confident on this one, compared to what I had when attempted
to port 'picnc' that got stalled, then I found Remora.
thanks.

Unfortunately the library doesn't support f303.
I have bluepill 103 and a F407 only. The 103 has 64k flash 20k ram.

so the cheapest dev/3d printer board would be the FYSETC S6 V2?
www.aliexpress.com/item/1005002393674651...-9a16-992c9065d361-0