High frequency and linuxcnc
- tcbmetalworks
- Offline
- Junior Member
Less
More
- Posts: 27
- Thank you received: 3
28 Oct 2024 04:48 #313355
by tcbmetalworks
High frequency and linuxcnc was created by tcbmetalworks
Hello. I recently bought a 10.5x25 foot plasma table running off a burny 10 plus lcd. I would like to upgrade it to modern servo motors and Linux cnc. I have a hypertherm ht2000 to go with it. I have a concern for rf shielding with this being a high frequency plasma unit. Is my concern realistic here? What are ways I can avoid the noise? Previously I was using a everlast 102i and had little to no issues with rf.
Please Log in or Create an account to join the conversation.
- tommylight
- Away
- Moderator
Less
More
- Posts: 19188
- Thank you received: 6432
28 Oct 2024 15:42 #313377
by tommylight
Replied by tommylight on topic High frequency and linuxcnc
It works, no doubt about it, just takes a bit of work and care, and some better cables.
See
forum.linuxcnc.org/plasma-laser/36734-le...ring-and-emi?start=0
forum.linuxcnc.org/49-basic-configuratio...works?start=30#56014
And
forum.linuxcnc.org/plasma-laser/38974-di...rything-in-one-place
See
forum.linuxcnc.org/plasma-laser/36734-le...ring-and-emi?start=0
forum.linuxcnc.org/49-basic-configuratio...works?start=30#56014
And
forum.linuxcnc.org/plasma-laser/38974-di...rything-in-one-place
The following user(s) said Thank You: Aciera
Please Log in or Create an account to join the conversation.
Time to create page: 0.125 seconds