Changing the openGL colors in the Axis GUI

phillc54 wrote: That was a trick question, betroot should be in every hamburger.

Absolutey!!! None of this pickles cr#p!

Good on ya, mate!updated file don't forget to rename it to .tclbeefy

Yes, "Exit" seems much better. For consistency it would be nice to have the "ESTOP", "OFF" and "ON" on the bottom left change color rather than background color.

I am not sure it is easy to have a "Rapid To Home" procedure hard coded. For instance home is not always 0 and some folk have Z0 at the top and some at the bottom and most lathes would be at the left so the tool would probably end up crashing into the chuck. The last "G90 G0 X0 Y0" doesn't suit me as only one of my machines has an axis with a home value of 0.

Onya mate, look'n good

edit

Lookin' good, I like the idea of toggling the tool touchoff and rapid to home.

Another thing that would be nice was if when the color changer is selected that it appeared with the current color selected

I have pushed this to the test branch.

ok revised in above message