VMC related HAL questions.

excuse my lack of knowledge. bracket?

CNCDoc wrote: 1001)

Should be:
(1001)

It's just a copy error on my part. If you look in the attached ngc file it is correct Not what is the error here.

CNCDoc wrote: Is this the cause of the error message above?

Nobody but you can know that.

You say that the error message is generated by your tool change remap code. So what causes that error to be printed?

(Does your system actually set spindle-oriented true once the spindle is oriented?)

If you have already posted your HAL, INI and remap files, then can you give a link to the message (of these 18 pages of messages) where the files are?

.