Trying to Configure Dual Y Axis

Looks like "=0" for homing sequence as homing is manual.
I don't have a "home all" button but can home them individually.

Routerworks wrote:

I am just reading that from your link. Do I put this under each axis? Do I need to put sequence number?
 

You put this under each JOINT  (all 4)
You can put 0 for the HOME_SEQUENCE or any other valid number.

I am changing to:

x axis sequence =1
y=-2
y=-2
z=-3
Will give it a try.
Thanks

Routerworks wrote:

I am changing to:

x axis sequence =1
y=-2
y=-2
z=-3
Will give it a try.
Thanks
 

I would try with z=0 instead of -3

To put it in the vernacular "Holy Cow" you did it. Looks like all the axis are working. All the motion is appropriate on the screen. X and Z move correctly. Looks like Y does also. Waiting for the Y motors to be delivered today and will hook them up. I'll let you know how it works out.

It's been a learning curve as most things are.
Can't thank you enough and everyone else for your help.

Regards,

Routerworks

GREAT!

This is a fantastic community here. Not long ago I was on the 'receiving side'. I'm glad I could help and give back a little.