Forum Menu

An open source Emco 120P lathe tool turret control

More
10 years 6 months ago - 10 years 6 months ago #73542 by LutzTD
Replied by LutzTD on topic An open source Emco 120P lathe tool turret control
yeah its only fair, it was your design and hard work after all. Ill post when they are gone.
Last edit: 10 years 6 months ago by LutzTD.

Please Log in or Create an account to join the conversation.

More
10 years 6 months ago #73601 by tome
Replied by tome on topic An open source Emco 120P lathe tool turret control
Actually, I wouldn't mind getting one of those boards. Would be good to have a backup. Let me know if that's possible and I can paypal you...
-Tom

Please Log in or Create an account to join the conversation.

More
10 years 6 months ago #73604 by LutzTD
Replied by LutzTD on topic An open source Emco 120P lathe tool turret control
IM me your address, Ill send you a couple for free.

Please Log in or Create an account to join the conversation.

More
10 years 6 months ago - 10 years 6 months ago #73614 by LutzTD
Replied by LutzTD on topic An open source Emco 120P lathe tool turret control
woohoo pcb's arrived today



Last edit: 10 years 6 months ago by LutzTD.
The following user(s) said Thank You: Rhine_Labs

Please Log in or Create an account to join the conversation.

More
10 years 6 months ago - 10 years 6 months ago #73615 by tome
Replied by tome on topic An open source Emco 120P lathe tool turret control
Look nice! I sent you a message (I think - may have been sent twice actually)...
-Tom

ps: where did you get them made?
Last edit: 10 years 6 months ago by tome.

Please Log in or Create an account to join the conversation.

More
10 years 6 months ago #73625 by LutzTD
Replied by LutzTD on topic An open source Emco 120P lathe tool turret control
I'll send a board out tomorrow. I got them from a proto house in China, they turned them very quick. www.pcbgogo.com/ stateside sources were 10X, much as I would have liked to get them made here in the US the price is prohibitive.

Please Log in or Create an account to join the conversation.

Time to create page: 0.270 seconds
Powered by Kunena Forum