Upgrading and migrating the LinuxCNC Forum
12 Nov 2015 17:34 #65169
by cradek
Replied by cradek on topic Upgrading and migrating the LinuxCNC Forum
In Windows XP you will have to use the http: url, not the https:, because Windows XP's https support is too old.
The following user(s) said Thank You: islander261
Please Log in or Create an account to join the conversation.
- Todd Zuercher
-
- Offline
- Platinum Member
-
Less
More
- Posts: 5007
- Thank you received: 1441
14 Nov 2015 03:20 #65217
by Todd Zuercher
Replied by Todd Zuercher on topic Upgrading and migrating the LinuxCNC Forum
It would be nice if there was a link back to the main Linuxcnc.org site at the top of the page.
Please Log in or Create an account to join the conversation.
- LearningLinuxCNC
-
- Offline
- Platinum Member
-
Less
More
- Posts: 320
- Thank you received: 48
14 Nov 2015 03:32 #65218
by LearningLinuxCNC
Replied by LearningLinuxCNC on topic Upgrading and migrating the LinuxCNC Forum
There is. it is the Home link at the top of the page.
Please Log in or Create an account to join the conversation.
- Razor_keen
- Offline
- Premium Member
-
Less
More
- Posts: 114
- Thank you received: 4
14 Nov 2015 05:28 #65220
by Razor_keen
Replied by Razor_keen on topic Upgrading and migrating the LinuxCNC Forum
I seem to not be able to reply in my own topic. Is there a good reason for this?
Please Log in or Create an account to join the conversation.
14 Nov 2015 06:48 #65223
by Rick G
Replied by Rick G on topic Upgrading and migrating the LinuxCNC Forum
Just tried in off subject/ test post.
Worked for me.
Rick G
Worked for me.
Rick G
Please Log in or Create an account to join the conversation.
- Razor_keen
- Offline
- Premium Member
-
Less
More
- Posts: 114
- Thank you received: 4
14 Nov 2015 07:05 #65224
by Razor_keen
Replied by Razor_keen on topic Upgrading and migrating the LinuxCNC Forum
the title of my topic was ubuntu 14.04.1 linuxcnc help. try that one
Please Log in or Create an account to join the conversation.
14 Nov 2015 13:47 #65242
by jepler
Replied by jepler on topic Upgrading and migrating the LinuxCNC Forum
Some categories were marked read-only after the upgrade. I've tried to correct them all. If you spot another one that doesn't allow replies or new posts, just reply here and let us know.
The following user(s) said Thank You: Razor_keen
Please Log in or Create an account to join the conversation.
15 Nov 2015 13:52 #65280
by gaston48
Yes!
with http instead of https
Replied by gaston48 on topic Upgrading and migrating the LinuxCNC Forum
It would be nice if there was a link back to the main Linuxcnc.org site at the top of the page.
Yes!
with http instead of https Please Log in or Create an account to join the conversation.
Time to create page: 0.085 seconds