StepConf StepScale and Encoder Scaling not right, following error

tommylight
Away
Moderator

23 Oct 2021 10:20 - 23 Oct 2021 10:21 #223978 by tommylight

Replied by tommylight on topic StepConf StepScale and Encoder Scaling not right, following error

Put 5.08mm for ballscrew pitch, might be inch one, i had one of those...

Last edit: 23 Oct 2021 10:21 by tommylight. Reason: wrong value

The following user(s) said Thank You: Redneck92

Please Log in or Create an account to join the conversation.

Redneck92
Offline
Senior Member

23 Oct 2021 10:39 #223981 by Redneck92

Replied by Redneck92 on topic StepConf StepScale and Encoder Scaling not right, following error

I will give this a try, thank you very much for the tip.

Please Log in or Create an account to join the conversation.

Redneck92
Offline
Senior Member

25 Oct 2021 17:03 #224285 by Redneck92

Replied by Redneck92 on topic StepConf StepScale and Encoder Scaling not right, following error

Almost forgot to reply back.

It actually seems that the pitch on the Z ballscrew is off. The ballscrew is new so I would have not thought about that.

I´m running it now with 4.92mm pitch and it is acurate within 0.005 to 0.01mm.

Could be better I think. But I will leave it how it is for now.

Thank you very very much again guys for the help.

Wish everyone a nice Week.

Please Log in or Create an account to join the conversation.

Time to create page: 0.068 seconds