Attached parallel board to breakout board can't open up linuxcnc anymore

I had bought and installed a parallel board (no drivers) and was able to set up and use linuxcnc wizard no problems.  I then attached the parallel port to a breakout board (new) and it all went south.I am attaching the report.No idea what to do.Thanks for any help  

Also report.

 

Error: could not insert module /usr/realtime-3.4-9-rtai-686-pae/modules/linuxcnc/hal_parport.ko: No such device

Looks like the parallel port is not found.

JT

I had issue as well, kernel less then 4 does not recognize attached boards. Install kernel 4.xx and higher then you'll get recognize you parport card.

I had bought and installed a parallel board (no drivers) and was able to set up and use linuxcnc wizard no problems.

What do you mean by installed? Pushed into the PCI/e slot or?

Were you able to test the card using Stepconf with the BOB attached to a stepper motor and driver?