LinuxCNC 32 BITS

Hello, thank you very much and a very Merry Christmas!...
It doesn't have that port, what board do you recommend for this little one?
Thanks a lot!...

Hello, thank you very much and a very Merry Christmas!...
Since I would like to see your project, maybe share it on your YouTube channel, I want to learn and I was really happy with the news that I could use Ubuntu to work seriously.
Thanks a lot!...

www.youtube.com/@tomaberisha5688/videos

www.youtube.com/@toma.cnc1/videos

Hello. Thank you very much for what you share with me. I have already subscribed to you, but unfortunately, you do not offer me the option to translate the audio from your videos into my Spanish. There is some tool in Linux to achieve this translation.
I will install the Ubuntu that they shared with me, but how much ram do they use to work with?
What USB board do you recommend for my 32-bit netbook? Very kind and excuse my ignorance...

Ubuntu 10.04 will work fine with 512MB of RAM.

Thank you so much!. My netbook, as already mentioned, has 2 gigabytes of ram and an SD, I don't know if a cable with a parallel port, via USB, that is functional to work directly with the GSK 980 TDb will be valid, which board do they use to connect to the lathe, after the parallel port?. It shouldn't be very difficult, since the cable of said lathe is a vga type, but with only 3 very thin cables, I think I read in your manual that that little lathe is 32 bits... Thank you very much again! Very kind for your patience with me.... Congratulations!...