Index to Linuxcnc & the Raspberry Pi (4 & 5) Official Images Only!!!

Intro:
I'm trying to index some of the issues, solutions and info contained in the thread mention in the title. As I would like to keep this "clean", it would be great if any new issues,queries additional info be posted here: forum.linuxcnc.org/9-installing-linuxcnc...official-images-only
(yes I know Raspberry is spelt wrong)
Cheers
Rob

General Stuff
About the Images: forum.linuxcnc.org/9-installing-linuxcnc...-only?start=0#320270

Networking Topics
Installation of Network Manager: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320949
Network Setup by behai: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320967
Additional Comments by Rodw: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320972
Ethercat Status: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#321684
Simple Mesa Setup without Network Manager by PCW: forum.linuxcnc.org/9-installing-linuxcnc...only?start=30#323321
wifi setup without Network Manager: forum.linuxcnc.org/9-installing-linuxcnc...only?start=40#323701

Locales:
Locales by behai: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320959

GPIO
Note that the below may help with those stuggling with Byte2Bot boards.
Regarding GPIO drivers: forum.linuxcnc.org/9-installing-linuxcnc...-only?start=0#320852
Basic Mill Config: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#321296

Video
Skewed Video Issue & Solution by 109jb: forum.linuxcnc.org/9-installing-linuxcnc...only?start=30#322167

Swap - zswap
Initial issue & Solution: forum.linuxcnc.org/9-installing-linuxcnc...only?start=30#322251

UI Isuues:
GMOCCAPY locking up when idle by U2fletch: forum.linuxcnc.org/9-installing-linuxcnc...only?start=40#323825
Solution: forum.linuxcnc.org/9-installing-linuxcnc...only?start=50#324087
Notes: This was related to zswap.
 

If we fix the berry bit will the links still be good or do they need modifying ?
Pinning it would be a good idea, was hoping you would ask
Locking just to keep it clean, I like it

Thanks
Tommy

Additional empty post 1

Additional empty post 2