Linux conversion for MDX540???
- RNJFAB
- Away
- Elite Member
-
Less
More
- Posts: 238
- Thank you received: 54
10 Apr 2025 11:57 #326029
by RNJFAB
Linux conversion for MDX540??? was created by RNJFAB
Hey All,
I was given an old Roland MDX-540 ( www.rolanddga.com/support/products/milli...0-3d-milling-machine ) and was wondering if its worth trying to LinuxCNC convet it.
Any thoughts?
I can currently use it with aspire then using the roland software run the gcode. No live tracking though. and aspire tool paths are a bit of a mission to setup.
Cheers
I was given an old Roland MDX-540 ( www.rolanddga.com/support/products/milli...0-3d-milling-machine ) and was wondering if its worth trying to LinuxCNC convet it.
Any thoughts?
I can currently use it with aspire then using the roland software run the gcode. No live tracking though. and aspire tool paths are a bit of a mission to setup.
Cheers
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 20201
- Thank you received: 6874
10 Apr 2025 14:24 #326036
by tommylight
Replied by tommylight on topic Linux conversion for MDX540???
I know i would.
Please Log in or Create an account to join the conversation.
- andypugh
-
- Offline
- Moderator
-
Less
More
- Posts: 23320
- Thank you received: 4946
15 Apr 2025 12:30 #326357
by andypugh
Replied by andypugh on topic Linux conversion for MDX540???
Have you seen the previous threads on converting this machine?
forum.linuxcnc.org/38-general-linuxcnc-q...dx540-rebuild#253265
forum.linuxcnc.org/38-general-linuxcnc-q...dx540-rebuild#253265
Please Log in or Create an account to join the conversation.
Time to create page: 0.087 seconds