7i76eu connection issues

Strange message from that

"Unsupported ethernet device 7I76eu at 10.10.10.10
No ETHERNET board found"

I am running linux cnc 2.9.4 and as far as I know the eu is supported

Your mesaflash version is too old to support the 7I76EU  but it found the card.

LinuxCNC 2.9.4 does support the 7I76EU

Are you sure the IP address in the hal file is 10.10.10.10?
 

Ah there we are thanks man! I had been doing everything through pncconf and was exiting out and saving changes without realizing it wasent actually writing the file. After modifying the file manually shure as shit were up and rolling.

Cnc machinist by trade lmao but super green on linux cnc and its showing lmao!