Not sure where to ask so, so I'll ask here

I bought this one
mesaus.com/product/7i76/

7i76 not the 7i76D, I have AM882's which you can set the rising edge is this what the difference between the 7i76 and the 7i76D?

Desertboy wrote: I bought this one
mesaus.com/product/7i76/

7i76 not the 7i76D, I have AM882's which you can set the rising edge is this what the difference between the 7i76 and the 7i76D?

Its here in the manual page one. www.mesanet.com/pdf/parallel/7i76man.pdf

Edit: And for the MPG's see this forum.linuxcnc.org/media/kunena/attachme...hluss_2017-01-02.pdf

The 7i76 supports stand alone MPG knobs not USB pendants which may or may not have Linuxcnc support.

I've had the USB pendant working in linuxcnc before although it was a PITA

this was 2017 so hoping it's a bit easier now.

I could probably get both working side by side which might not be a bad idea.

I use a non USB wireless pendant that has a hard wired receiver that uses one of the 7i76e mpg

I use a non USB wireless pendant that has a hard wired receiver that uses one of the 7i76e mpg

Sounds interesting. Could you provide some more information on that?