- Posts: 18115
- Thank you received: 5334
Rote LED
- PCW
- Offline
- Moderator
-
Less
More
- Edi_48
- Offline
- Senior Member
-
Less
More
- Posts: 68
- Thank you received: 0
- PCW
- Offline
- Moderator
-
Less
More
- Posts: 18115
- Thank you received: 5334
- Edi_48
- Offline
- Senior Member
-
Less
More
- Posts: 68
- Thank you received: 0
- PCW
- Offline
- Moderator
-
Less
More
- Posts: 18115
- Thank you received: 5334
1 year 4 months ago #330453
by PCW
Replied by PCW on topic Rote LED
rtt min/avg/max/mdev = 0.085/0.161/3.281/0.042 ms
is better but still not good
Take a look at this thread, especially the kernel command line (setup with grub)
forum.linuxcnc.org/18-computer/56380-error-finishing-read-sigh
is better but still not good
Take a look at this thread, especially the kernel command line (setup with grub)
forum.linuxcnc.org/18-computer/56380-error-finishing-read-sigh
- Edi_48
- Offline
- Senior Member
-
Less
More
- Posts: 68
- Thank you received: 0
1 year 3 months ago #331163
by Edi_48
Replied by Edi_48 on topic Rote LED
Hallo ich habe wieder einen Fehler, anderer Rechner AMD 3500
Mit Realtec Chipsatz, DKMS Treiber installiert. Ehternet Verbindung steigt mitten im Programm aus. Was kann ich noch tun
60000 packets transmitted, 59995 received, +5 errors, 0.00833333% packet loss, time 60033ms
rtt min/avg/max/mdev = 0.052/0.106/0.265/0.030 ms, pipe 2
Mit Realtec Chipsatz, DKMS Treiber installiert. Ehternet Verbindung steigt mitten im Programm aus. Was kann ich noch tun
60000 packets transmitted, 59995 received, +5 errors, 0.00833333% packet loss, time 60033ms
rtt min/avg/max/mdev = 0.052/0.106/0.265/0.030 ms, pipe 2
Moderators: Muecke
Time to create page: 0.601 seconds