adding a pendant to the system

ok i got an old pendant that operates via USB with simple 15 NO push buttons on it whent cmd and tiped less /proc/bus/input/devices as stated on the wiki pages got the pendants address as

I: Bus=0003 Vendor=04d8 Product=0055 Version=0111
N: Name="Microchip Technology Inc. Keyboard Demo"
P: Phys=usb-0000:00:1d.0-2/input0
S: Sysfs=/devices/pci0000:00/0000:00:1d.0/usb2/2-2/2-2:1.0/input/input5
U: Uniq=
H: Handlers=kbd event5
B: EV=120013
B: KEY=10000 7 ff980000 7ff febeffdf ffefffff ffffffff fffffffe
B: MSC=10
B: LED=1f

so i went and added "loadusr -W hal_input -KRAL Demo" to the main .hal file and got error message when trying to start emc2

What am i doing wrong?

running latest stable version of linuxCNC (EMC2.4.6) in Ubuntu 10.04 LTS - the Lucid Lynx

what is the man page?

did the bottom part but still same error...was the page i used but only got to step 3

wait... step 3 is not in the main hal page of my current emc program?

ok still doesn't seem to like it thou even with the

SUBSYSTEM=="input", mode="0660", group="plugdev" added into
sudo nano /etc/udev/rules.d/51-plugdev.rules