Basic configuration for a chinese 6040 cnc router please

there might be a Estop chain Hint
check the full pinout as input is connected

So
pin1 = estop
pin2 = X step
pin 3 = X dir
pin 4 = Y step
pin 5 = Y direction
pin 6 = Z step
pin 7 = Z dir

pin 14 = Amplifier enable

At this point I think I'll go to bed.....a little progress anyway!

Is there any documentation with the machine? It seems odd that they expect you to work it out entirely for yourself.

Hi, I have been promised it, repeatedly. I asked before I bought and was told yes we'll send it, so far, despite re-asking, no They will get a crap review on service.

3/4axis jb3163 type is a clont of a chinese? clone? pics Ive seen of the "real" chinese clone list the above and a board revision, this clone is blank.

Anyway with movement the worst job is solved, now its calibration. Though it has no homing switches so these I have to fit and configure.

Where is the best point to put homing switches? lower front left? Z at lowest movement point I assume?

Seems no docs,

"hello dear friend，sorry we don't supply a manual with item，cause the manual is Chinese，no English manual.
best regards"

So I'll look for a new board that has a manual and try and claim that back off their sorry ass....

Ask for the Chinese one. The numbers are probably the same.
(and it probably includes Mach3 screenshots anyway)