what is glade?? my cnc has joint x =joint 0, Y joint 1 and joint 2, Z joint 3 at ini file, but not have homing button "all homing" ad not move minus, ig make mdi G0X100F200 go to this point, but not go back G0X–100F200 all axis same no move. and if try use Z axis not move any + or -. not can homing,not move all, not move minus. this is my first liux and linuxcnc i not understand any this how make dual Y. why not have option in setup wizard, if have option XYZ , XYZA, foam, lathe but not normal setting XYYZ why.
my machie not have limit SW yet ,wait when come to post i has orden. my cnc wizaed has make table size 0 to 900 Y. 0 to 800 X , and 0 to 200 Z, not can setting more under table size site. home / limits etc, i not know, not have wired yet.
manual i can move Y and both motor run + and –. MDI G-code not move, alltime something error if try move minus only plus move.
