Forum Menu

LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15

More
5 years 8 months ago #199227 by gaston48
Replied by gaston48 on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15
Thank you,
yes there is a bug, I had to do the same
the other solution is to preprocess file.comp to file.c with halcompile from 2.7
and then install file.c with halcompile fron 2.8.1
The following user(s) said Thank You: joekline9

Please Log in or Create an account to join the conversation.

More
5 years 8 months ago #199340 by gaston48
Replied by gaston48 on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15
Obviously 2.8.1 under axis limits the size of the xml file linked to PyVCP ?
the syntax of my xml is good it is big and has 3 tabs

File Attachment:

File Name: mikron_xml.txt
File Size:9 KB

Please Log in or Create an account to join the conversation.

More
5 years 8 months ago #199384 by andypugh
Replied by andypugh on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15

joekline9 wrote: 2.8 has a bug when it comes to userspace singleton comps.


This seems to be a bug in 2.7 too:

github.com/LinuxCNC/linuxcnc/issues/245

Please Log in or Create an account to join the conversation.

More
5 years 8 months ago #199385 by andypugh
Replied by andypugh on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15

andypugh wrote: This seems to be a bug in 2.7 too:
github.com/LinuxCNC/linuxcnc/issues/245


And apparently got fixed in Master but not in 2.7 / 2.8:
github.com/LinuxCNC/linuxcnc/commit/2caf...d31b371591733070abdf

Please Log in or Create an account to join the conversation.

More
5 years 8 months ago #199392 by andypugh
Replied by andypugh on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15

gaston48 wrote: Obviously 2.8.1 under axis limits the size of the xml file linked to PyVCP ?


This might be a config problem.

What does
Code:
ulimit -l
tell you?

wiki.linuxcnc.org/cgi-bin/wiki.pl?LockedMemory

However on my systems this shows 65536 which should be more than enough.

Please Log in or Create an account to join the conversation.

More
5 years 8 months ago #199394 by gaston48
Replied by gaston48 on topic LinuxCNC 2.8.1 configuration doesn't run after upgrading from 2.7.15
Hello Andy

this gives ?
utilisation ulimit [-SHabcdefghij .....xPT] [limite]

Please Log in or Create an account to join the conversation.

Time to create page: 0.346 seconds
Powered by Kunena Forum