Ethercat drive configuration woes

The drives are all identical.

I did try swapping the order of the drives incase it was a faulty drive, but it never made any difference. It's only ever the 2nd and 3rd drives in the chain that can be enabled.


I tried the suggestion in your previous post this morning before leaving for work, about unlinking the opmode pins, and issuing 8 via halcmd, but it didn't make any difference.
The lcec.0.N.opmode showed as 8 in Hal config, but the drives were still returning a opmode/statusword of 0.
I'll try again when I get home, just to make sure I did change the correct things.

Forgot to mention that LinuxCNC loads up with no errors reported, even if no slaves are connected.

Just ran through a few things.

First attempt-
Load up LinuxCNC, but leave drives disconnected.
LinuxCNC loads without any errors, but EtherCAT reporting various messages via dmesg (as I'd expect, as the requested slaves can't be found)
Connect drives. Drives configure as 123.
Try jogging. Motors don't move, but hear drives disabling (clicking) when following error is triggered.
Remember opmode is still disconnected in Hal.
Open Hal config, and find statusword and controlword are reporting correctly.
Issue opmode 8 to each drive via Hal Command, and all axis are under LinuxCNC control.

Now I tested various things.
The opmode doesn't actually make any difference. If I add the opmode nets back into my hal, it makes no difference.
Provided I load up LinuxCNC with the drives disconnected (network cable unplugged from the master, or the drives not powered on), then connect/power on the drives, they configure, and can be enabled/controlled via LinuxCNC.
If you load LinuxCNC with the drives connected, they configure, but won't enable. No amount of disconnecting/power cycling the drives will get them to enable.

The key thing during all this, is LinuxCNC not reporting the correct statusword.
When LinuxCNC loads with the drives connected, the statusword is always reported as 0.
Check the statusword via a terminal, the statusword is shown correctly (0x250 or 0x231), and the status word is even shown correctly in the frame data (ethercat debug  level 2). But it shows as 0 at lcec.0.N.statusword.

If you connect the drives after loading LinuxCNC (it doesn't matter if the drives are freshly powered on, or still showing as configured/slaves from a previous load), then LinuxCNC reports the statusword correctly, and the drives work as expected.


So the problem appears to be LinuxCNC not retrieving the correct value if it loads with the drives connected.

there is something strange with your installation or they changed important things in the etherlab master.

-Can you please try if you can start linuxcnc, after an fresh reboot without drives connected.

-please post the ethercat pdos -v output from an slave, after reboot, without starting linuxcnc.

-please post actual ethercat.xml and halfile

LinuxCNC starts without any reported errors after a fresh reboot, with no drives connected.

pdos -

Hal and xml, since the editor didn't post them on the last post