Ethercat build from source - full instructions

CORBETT wrote:

Rod, I was proud of that sticky... but you were the one that got it up there to start with.

Sorry, I noticed several people were trying to mix this and the repositories together and needlessly getting into trouble because of that.
Plus the ethercat driver source should be coming from this repository because its maintainrd and has had a lot of changes
github.com/linuxcnc-ethercat
It has a buildbot that publishes itself on the ethercat repos.

thanks for the detailed step by step post, how to add an Ethercat AC Servo and test if it moves

thanks

Hello sir, I am trying to install linuxcnc xinje servo driver but I don't know if I am making a mistake due to the configuration. I would be very happy if you could help me. Thank you.

Hello sir, I am trying to install linuxcnc xinje servo driver but I don't know if I am making a mistake due to the configuration. I would be very happy if you could help me. Thank you.

 

@Halil
Start a new topic for configuration issues, this is for installation only.
Thank you.

This thread almost worked for me, I have a mismatch between ioctl() version magis is differing: /dev/EtherCAT0: 37, ethercat tool: 33. What is the best way to correct this?