Spindle Load feedback in Gmoccapy

I see it:
 
I tested it, and it works.

Could you send your config?

Dear ZZ,
thank you so much, with the postgui.hal was the right idea!
It is working!!
Now i understand why this message "pin or signal doesnt exist"
Gmoccapy is not loaded and the pins exist after loading the GUI.

Cheers
Reinhard

Hello! Could you maybe point out what changes neet to be made to run the spindle_load within LinuxCNC 2.8? on my simulation computer uname puts out the following: 4.19.0-21-rt-amd64 #1 SMP PREEMPT RT Debian 4.19.249-2

I also tried to install glade using apt-get install glade glade-gtk2. But when trying to open spindle_load.glade within the glade GUI I get en error message that the gladevcp catalog is missing.

Thanks for your help!

I have same problem.

For making it Python2 compatible the glade file doesn't need to be changed afaik. Only the Python script needs adaption. I can post a Python2 version tomorrow.

Apparently I was wrong, sorry. The Glade file needs a change. The line  has to be changed to to work with Gtk2.
Moreover, there is no Python file needed at all for that simple use case. Sorry again for that complication.
So the attached Glade file should work for both LinuxCNC 2.8 and 2.9 with this configuration:
You will see a float pin named spindle_load.bar_spindle_load.
The scale is 1, so setting this pin to 100 will display 100.