Opening PlasmaC Axis Config in Maximised Form

Hi Guys,

When I open my PlasmaC config using Axis it will always load and not open up but is minimized to the task bar,

Also when I click the link in the task bar it opens but is in its minimized form, I always need to click to maximize the screen.


How can I set it up so that when I click on the desktop icon it will open up without going to the task bar and fully maximized?

In the ini file, [PLASMAC] section

change:
to:

you may have not searched
look here
forum.linuxcnc.org/forum/21-axis/29735-axis-modifications

search is always your best fiend and first try

there is also a full guidence
online
linuxcnc.org/docs/devel/html/plasma/plas...l#_axis_gui_specific

Ok I have followed Phills advice with the setting in the ini file and that has fixed one of the problems.

The other is when I open my desktop shortcut the program opens minimized to the task bar. I have searched for the answer but I am not sure exactly what setting would be controlling that.

What happens if you run your LinuxCNC config from a terminal?