New component for keyboards and panels.

Sorry, I mean install from USB images. LinuxCNC 2.8.4 released

thank you for the advice I can now hit the response button.

but still like you said When turning off and on Access rights will not work.

Is there any way to call the 0660 permissions on startup?

in udev.conf must edit ?

Yes, it is possible but I don't know what GUI you are using, could you send me a screenshot. Are you using Debian?

COFHAL wrote:

Yes, it is possible but I don't know what GUI you are using, could you send me a screenshot. Are you using Debian?
 

yes i use debian with linuxcnc 2.8.4 gmoccapy gui.

I really don't know, I'm using this component with raspian and with root privileges, therefore when I change the permissions I was able to keep them, because I don't need a password to run sudo chmod 666 /dev/input. Today I tried to do it on a PC, but it always asks me for a password when executing the sudo command. I haven't found a way to run a script without being prompted for the password.