Update help ---- PoKeys No moore

More
5 years 9 months ago #194956 by tecno
Replied by tecno on topic Update help
So..

Now I have Debian10 working on the lathe Gigabyte -1900 working as regards LCNC.

Touch is not working yet so now trial and error is the way to go.

It is a eGalaxy /USB touch screen. sold as separate screen + USB adapter.

Please Log in to join the conversation.

More
5 years 9 months ago #195041 by andypugh
Replied by andypugh on topic Update help
When I first set up an eGalaxy touchscreen I needed to install drivers.

I thought that this was no longer required with the newer kernels.

But additional drivers do exist: www.eeti.com/drivers_Linux.html

Please Log in to join the conversation.

More
5 years 9 months ago #195441 by tecno
Replied by tecno on topic Update help
Took up a Touch screen from my mill that is easier to disconnect and found this :(

Attachment not found



Seems that the screen is damaged probably due to low temperatures, who to blame MrMurphy

Please Log in to join the conversation.

More
5 years 9 months ago #195443 by andypugh
Replied by andypugh on topic Update help
Was it still cold?

I regularly chill laptop screens down to -30C and have never seen any permanent damage.

Please Log in to join the conversation.

More
5 years 9 months ago #195444 by tecno
Replied by tecno on topic Update help
No, took it up last evening and let get room temp before I powered up.

The temp never goes lower than 3-5°C in the shop.
The monitor an old LCD from Philips 170B4 so that might explain why ;)

Please Log in to join the conversation.

More
5 years 9 months ago #195446 by tommylight
Replied by tommylight on topic Update help
I would say moisture, but it is past that, that is water ingress.
Still looks salvageable just dry it properly for at least 2 to 3 hours at 60-65 degress C.

Please Log in to join the conversation.

More
5 years 9 months ago #195466 by tecno
Replied by tecno on topic Update help
That is also possible, anywho I will try the owen and see if it helps.

Please Log in to join the conversation.

More
5 years 9 months ago #195510 by tommylight
Replied by tommylight on topic Update help
Is it cooked yet? :)

Please Log in to join the conversation.

More
5 years 9 months ago #195523 by tecno
Replied by tecno on topic Update help
Not yet, still unsure if the added touch foil will withstand the temperature?

Please Log in to join the conversation.

More
5 years 9 months ago #195567 by tecno
Replied by tecno on topic Update help
Decided not to risk the Touch foil.

www.a1touchsolution.nl/sites/default/fil...t64_1.06.0704.tar.gz

Trying to get this driver to work as the other EETI I can not get to work.
The Touch driver install gives me the creeps, why does it have to so bloody difficult?

Please Log in to join the conversation.

Time to create page: 0.524 seconds
Powered by Kunena Forum