Update help ---- PoKeys No moore

More
5 years 9 months ago #196773 by tecno
Replied by tecno on topic Update help ---- HAL issues

Attachment not found



All functioning but no axis movement.

Please Log in to join the conversation.

More
5 years 9 months ago #196782 by andypugh
Replied by andypugh on topic Update help ---- HAL issues
Maybe feed hold? Feed override?
Does anything move on screen?

Please Log in to join the conversation.

More
5 years 9 months ago #196794 by tecno
Replied by tecno on topic Update help ---- HAL issues
Now I have been down in the workshop and tried everything possible but nothing moves on the screen / axis.

Axis move with keyboard and touch screen.

Looks like there must have been major updates with GMOCCAPY so my old settings are no longer valid. No moves from PROBE screen either.

Please Log in to join the conversation.

More
5 years 9 months ago #196806 by andypugh
Replied by andypugh on topic Update help ---- HAL issues
If you are driving the axis/joint.xxxxx jog pins correctly then the GUI is not even involved.

Though... You can't jog an axis until the machine is homed, at that point you are jogging joints. So you could check the joint jogging pins.

It sounds like motion isn't enabled, or feed rate is set to zero, or something like that.

Please Log in to join the conversation.

More
5 years 9 months ago #196807 by tecno
Replied by tecno on topic Update help ---- HAL issues
Will look at this tomorrow. Will not go out now as it is -11°C outside and workshop is 15.75°C right now so machines are not freezing ;)

As we say here it is mosquito free LOL

Please Log in to join the conversation.

More
5 years 9 months ago #196915 by tecno
Replied by tecno on topic Update help ---- HAL issues
So, there is nothing on joints!The update script has not converted all data as looks like now.

Attachment not found


Attachment not found

Please Log in to join the conversation.

More
5 years 9 months ago #196917 by andypugh
Replied by andypugh on topic Update help ---- HAL issues
Does it jog after homing?

Please Log in to join the conversation.

More
5 years 9 months ago #196919 by tecno
Replied by tecno on topic Update help ---- HAL issues
No

Nothing new in HALUI

Please Log in to join the conversation.

More
5 years 9 months ago #196920 by andypugh
Replied by andypugh on topic Update help ---- HAL issues
It's not the unconnected joint jog enables then.

Please Log in to join the conversation.

More
5 years 9 months ago #196922 by tecno
Replied by tecno on topic Update help ---- HAL issues
To me this looks to be unconnected
Code:
# The encoder output counts to the axis. Only the selected axis will move. net encoder-counts <= encoder.0.counts net encoder-counts => joint.0.jog-counts axis.x.jog-counts net encoder-counts => joint.1.jog-counts axis.y.jog-counts net encoder-counts => joint.2.jog-counts axis.z.jog-counts

Please Log in to join the conversation.

Time to create page: 0.761 seconds
Powered by Kunena Forum