Сustomization QTvcp

All_homed button indicates if the machine is homed. If you don't home then it indicates this - there is no way around this.
You can use linuxcnc without homing, but it is not recommended.

starting with x0 y0 z0:
from documentation:

POSITION_FILE = position.txt - If set to a non-empty value, the joint positions are stored between runs in this file. This allows the machine to start with the same coordinates it had on shutdown. This assumes there was no movement of the machine while powered off. If unset, joint positions are not stored and will begin at 0 each time LinuxCNC is started. This can help on smaller machines without home switches. If using the Mesa resolver interface this file can be used to emulate absolute encoders and eliminate the need for homing (with no loss of accuracy). See the hostmot2 manpage for more details.

in [TRAJ] header remove POSITION_FILE=

Axis keeps the position, I can continue the program. And QtDragon
no and the interface is locked. Qtaxis also works.

Please post your INI file.

You are welcome!

?
I need to see your INI file.

oh there it is..

change:
to

Thank you! Does not load the file, it needs reload, macrotab (run) does not work. Position saves. In the screenshot how it works in qtpyvcp.

to stop position being saved:

#POSITION_FILE = position.txt

does not load the file:
I don't understand.

macrotab does not run:
Ok I'll test to see why.

All Homed is missing as in Qtpyvcp. All Homed will decide everything at startup.